This is a love of mine , creating old aged looking unique works that anybody can do , but who cant collect or is in an area that doesn’t have old Yamadori or simply cant afford great works . This took about 16 hours to create from scratch . The junipers were about 16 years old growing in my garden for 10 years in very poor soil then collected and potted into bonsai dishes then left to their own device .
Very little care or training was involved as the rest of my vast collection appealed to my senses rather than rubbish like this . Young nursery stock would probably be easier to work with as these were set rigid due to their age .The wood is actually an old pine tap root 
or part there of , collected from a forest .It had been laying above the ground and the borers and grubs etc have removed and cellulose material and left the resinous part of the root ,It was probable a bit chewy for the insects .
After selecting several pieces i returned home to clean them up . I carve the area’s that are too thick or try to add a bit more movement and character to the wood
then with a wire wheel brush in a power drill to remove any soft material
and to clean them up .After planning the design i place the required trunk onto the wood and draw a line to be carved . I always carve at least 60-70 percent of the trunk thickness into the wood
. I have used Lime Sulfur on this occasion to protect the wood from fungus and to high-light the wood as the jin and shari 
.Personally i don’t like bleached material so i will tone it down with a bitumen based steri-prune sealer at a later date .
Recessing the trunks into the wood gives an instant aged look and securely holds the tree in place . Solid brass of Stainless steel screws only are used to anchor the trunk and branches in place .Pre drill the juniper is advised . I place the rear tree into position and attach with the screws 
, then secure the front tree 
. Next it is potted with the anticipation of the correct placement , but it rarely works out . It can always be rotated next season as this is only a trainer in a training pot .
Now the work begins to trim the foliage prior to wiring , i start with the front
as time goes by i get a little rough and take short cuts so the front demands my attention . With the tree wired and shaped some-what i move to the rear and begin to trim and wire .Then with this task complete
i style it to suit my original plan 
.Note the bar branches at the rear ,
i’m not concerned as i said its a trainer and some of these branches will be jinned
.With a rough style complete its onto the bench and contemplating the next challenge . Cheers Alpineart