Page 3 of 3
Re: Creating a Twin Trunk from a Non Twin Trunk
Posted: October 31st, 2014, 9:47 pm
by Ray M
Hi everyone,
Here are some update photos of the Swamp Cyprus.
IMG_9706 -2.jpg
IMG_9707 -2.jpg
IMG_9708 -2.jpg
IMG_9710 -2.jpg
Regards Ray
Re: Creating a Twin Trunk from a Non Twin Trunk
Posted: October 31st, 2014, 10:01 pm
by Ryceman3
Hi Ray,
Yep... It's official, this man can layer just about EVERYTHING!
Correct me if I'm wrong... anyone? Didn't think so!
Another success story, well done!
Re: Creating a Twin Trunk from a Non Twin Trunk
Posted: November 14th, 2014, 3:50 pm
by Ray M
Hi all,
The next step with the Swamp Cyprus.
IMG_9732 -2.jpg
I did flat cuts and will wait to see what new leaders appear. I'm not sure I have cut the trunks down enough.
I might need to lower them to create tapper down lower. Any comments are always welcome.
IMG_9737 -2.jpg
IMG_9738 -2.jpg
The roots are growing very well.
Regards Ray
Re: Creating a Twin Trunk from a Non Twin Trunk
Posted: January 9th, 2015, 10:15 am
by Ray M
Hi folks,
An update on how the Swampy is going.
IMG_9942 -2.jpg
IMG_9943 -2.jpg
IMG_9945 -2.jpg
IMG_9947 -2.jpg
IMG_9949 -2.jpg
IMG_9951 -2.jpg
IMG_9954 -2.jpg
Regards Ray
Re: Creating a Twin Trunk from a Non Twin Trunk
Posted: March 15th, 2016, 1:46 pm
by Ray M
Hi folks,
After I cut the top out of the remaining stock tree I decided to apply another layer. I was out doing work with the trees this morning and thought I should check this layer. After removing the alfoil to check, I was glad I did as it is chocker block of roots.
IMG_4356 -1.jpg
IMG_4358 -1.jpg
I'll remove the layer on Thursday at the School of Bonsai.
IMG_4362 -1.jpg
Regards Ray