Page 4 of 4
Re: Carved Elm trunk
Posted: January 22nd, 2012, 12:41 pm
by Beano
Hi,
I'm new here, this is my first post. Those trees look fantastic!!! Here I would have thought suffering their tearing from the ground would have killed them. Very nice job, well done.
Re: Carved Elm trunk
Posted: January 22nd, 2012, 6:23 pm
by alpineart
Him Beano, welcome aboard mate. Elms are pretty hardy ,they grow from root cuttings , sucker up well and survive being grasped in a 3 way bucket and ripped out of the ground by a bobcat . Most still bear the scars from the bobcat bucket clamping down on the lower trunk At the time of collection i had to use a pick to remove the clay so i could get them into the tandem trailer . Goes to show you how well a graft actually knits together , none broke at the union , some were severed from the bucket which basically chopped them off . I kill more tree's with my hack and chop attitude , then again i can kill anything when it comes to Bonsai.
Cheers Alpineart
Re: Carved Elm trunk
Posted: January 23rd, 2012, 9:23 am
by MattA
Hey Alpine,
Dry rot is the usual culprit but its interesting that none of your trainers have suffered any so far, maybe carving them out like you did has actually helped prevent it (air & wind etc). I have a few trees that were butchered but not carved out & most have been full of dryrot after a couple of seasons. Having said that I took the log splitter to another trunk thats been recovering in my garden, I had expected the white ants to have done a fair bit of work after 3yrs, no such luck its still solid as a rock. Might have to take the Arbortech to it
The foliage variation is even more intriguing, no point in speculating, just enjoy the uniqueness I say. Good luck with getting a totally accurate ID, I have more than a few here that I will probably never know for sure, no matter I like them for what they are.
Matt
Re: Carved Elm trunk
Posted: January 23rd, 2012, 9:39 am
by alpineart
Hi MattA , last year was one of our wettest and the humidity was light the Daintree. If anything was going to rot it most certainly would have began then . I have a few unknown species is just niggles me not know what the actually are . I create humidity around most of my trainers with sand trays /wet beds and it doesn't affect any of them .Now and again i might drown a pine but that a rare event . Good open air circulation is a must except in this hot weather where the radiant heat becomes the issue .I slice them open so i believe this dries them out quite evenly .I do have one trunk i simply drilled a 30mm hole down from the top and with no out let for water to leave , just a little test . That trunk died , however it didn't rot ?
Cheers Alpine
Re: Carved Elm trunk
Posted: February 13th, 2012, 9:17 pm
by alpineart
Well i got sick of looking at Cedars so i give a couple of elms a work-over
100_9637.jpg
100_9639.jpg
100_9647.jpg
100_9638.jpg
100_9654.jpg
100_9657.jpg
These will now be defoliated then allowed to leaf out and with a bit of weathering the final detailing of the carved area's will take place . The dry wood is very stable considering the humid weather last year and the daily watering with the hose no rot was struck during the carving process .I liken the hardness of the wood to that of kiln dried Alpine ash or KDHW . I enjoyed these two jobs , so i will tackle a few more during this week .
Cheers Alpineart
Re: Carved Elm trunk
Posted: February 15th, 2012, 11:55 am
by alpineart
A little bit more inspiration and another 2 trunks carved .These required defoliating in order to get the carvers in to do the job .This Golden Elm
100_9664.jpg
had a reverse taper at the graft union
100_9666.jpg
100_9667.jpg
100_9668.jpg
, while it is not completely sorted it will need further work .
100_9670.jpg
100_9673.jpg
A close up of the carving
100_9671.jpg
100_9672.jpg
100_9674.jpg
This smaller trunk has 2/3 green foliage and 1/3 golden leaves .
100_9675.jpg
100_9676.jpg
100_9677.jpg
Its a pity the foliage wasn't balanced but i can always remove a green trunk to improve the overall look .Acloser look at the carving . These can now grow on until i find the time to revisit the carvings .
Cheers Alpineart
Re: Carved Elm trunk
Posted: August 2nd, 2013, 3:51 pm
by alpineart
This is the last of the trunks collected
P1070671.JPG
. The curl grabs had managed to get to these , i picked out at least 50 odd grubs from these 6 pots today . Oddly enough the Chinese Elm posted earlier had no grubs in it and it was growing in the same decomposed pine bark blend . I have hard root pruned these for the 3rd time since collecting them in the attempt to get them to flat bottoms
P1070672.JPG
P1070673.JPG
P1070674.JPG
P1070675.JPG
P1070676.JPG
P1070677.JPG
P1070678.JPG
P1070679.JPG
P1070680.JPG
P1070683.JPG
P1070684.JPG
P1070685.JPG
P1070686.JPG
, still a few seasons to go but progress is being made . I only have 10 of these left , i did sell a few and the curl grubs and high temps claimed the rest last year. All of these are Ulmus Glabra Lutescens or Golden Wych Elms . Look forward to doing some carving on these in the future .
Cheers Alpineart
Re: Carved Elm trunk
Posted: September 18th, 2015, 10:20 am
by alpineart
A couple of the survivors that I hung onto , some died , others where sold .These are getting another trim and shape after leaf out .
P1110026.JPG
P1110027.JPG
P1110028.JPG
P1110029.JPG
P1110030.JPG
P1110031.JPG
The carving can be done at any time ,
P1110032.JPG
P1110033.JPG
P1110034.JPG
P1110035.JPG
Reverse taper , in there is the challenge .
P1110036.JPG
P1110037.JPG
P1110038.JPG
P1110039.JPG
Nice taper on this one .I have removed a section of dead wood with the sabre saw on both trunks to make carving a little easier if and when it takes place .
Cheers Alpineart
Re: Carved Elm trunk
Posted: November 21st, 2015, 1:36 pm
by alpineart
This had a touch up today , I have removed the English elm foliage suckering from the root stock ,
P1110303.JPG
P1110304.JPG
P1110305.JPG
P1110306.JPG
P1110307.JPG
P1110308.JPG
had a play with altering the reverse taper and a bit of rough carving to to make a bit of progress on the trunk .
Cheers . Alpineart
Re: Carved Elm trunk
Posted: February 3rd, 2016, 11:37 pm
by Homer911
Great progression. ... love it
Sent from my SM-G900I using Tapatalk
Re: Carved Elm trunk
Posted: February 4th, 2016, 5:52 am
by alpineart
Hi Homer011 , mate the remaining trunks I have here are progressing slow but well , considering the lack of real care . I will ask Fiveoffive to do a topic on his purchased tree . I have seen it at our club meetings and with good care

it has turned into a very nice developed works in progress .
Cheers Alpine
Re: Carved Elm trunk
Posted: February 4th, 2016, 11:16 am
by Kevin
Hello Alpineart,
Thankyou for sharing your unique approach.
I am constantly in awe of your ethos and the individual works you have performed with your many specimens over many years. Your tenacity in converting landscaped trees to happily abode into bonsai sized pots is incredible.
Do you have a collection of Alpineart favourites? If so, how many and their real / bonsai ages. I would imagine these would all have been collected and trained by yourself from the beginning. I would love to see the Alpineart pride collection or at least a glimpse into one of them.
Thanks.
Kevin
Re: Carved Elm trunk
Posted: February 4th, 2016, 8:16 pm
by alpineart
Hi Kevin , mate thanks for the positive feedback . While I do collect or try to salvage plenty of material , not all survives . I have killed plenty and sold many , a lot of material has been sold to members here with the request that a topic be started on each and every tree , trunk , trainer and seedling sold . I have yet to see a handful of topics and they should measure in the hundreds .
Most that visit leave with the better material if the price is right I keep the unique and unusual which I endevour to keep alive . My yard is like an organized jungle of plants at various stages of development and potted material exceeds 500 plants . Do I have a few favorites , well yes I do and I can count them on 1 hand , however everything here is uniquely different and a various stages so I really like them all .
Photographing large material is a task and a half just moving them and the time is not really available , neither is trimming all the stock but i manage to trim almost everything at least once a year . I have thought about putting a few in my album but that hasn't eventuated , maybe its time it did .
Cheers Alpineart
Re: Carved Elm trunk
Posted: February 5th, 2016, 12:29 am
by Kevin
Thanks for the feedback Alpineart.
Much the same as 'Good Friends', they say you can only count them on one hand too.
Looking forward to viewing those few Alpineart favourites - when time permits.
Drop a note into the cafe when you do load them into your album.
Thanks,
Kevin