AusBonsai

Height 320mm, Width 200mm
purchased from Riverview Nursery late 2010. As the tree was very tall and lanky, the top was layered off September 2011.
This is the lower section and was bent by drilling the trunk and clamping to a steel tube with a Cork as a pivot point. Ken

Ken I like the contraption U used for bending it...and how You bent it. Thanks I shall do the same.

Well the tree has progressed slowly.
It go attacked by scale this year and has been sprayed with Confidor so hope all gone now.

the holes did not roll over yet, so cut a small section of eucalyptus twig and jammed it into the holes then cut it off. they look much less intrusive now and time wil age them hopefully

Ken

In many years to come, this will look beautiful. Once that leader thickens and grows like crazy, it should hopefully give better taper.

bonsaibuddyman wrote:In many years to come, this will look beautiful. Once that leader thickens and grows like crazy, it should hopefully give better taper.

Thanks that is what I am hoping to happen

Ken