Exactly what craig said. Most decidous and broadleaf trees will be ground grown for the trunk only, once the tree's are lifted they are stripped of all branches as they are usually too thick for the design and the internode length of new branches are too long to be incorporated into the design. For me, this wouldn't be an issue for say, Ficus, because they will back bud anywhere possible.
When it comes to Conifers, a little more care should be taken, though I don't have enough experience with these.
Finally have my ground growing area!!!
-
- Aussie Bonsai Fan
- Posts: 212
- Joined: October 11th, 2012, 1:56 pm
- Favorite Species: Juniper/azalea
- Bonsai Age: 1
- Location: Blue mountains nsw
- Been thanked: 1 time
- Contact:
Finally have my ground growing area!!!
Cheers for all the replies guys. I was thinking kind of in reverse, as in "trunk" "nebari" then branching? I will do some reading tonight and work out exactly what is needed for each specific tree and sort it on Sunday. As for spacing, I had a second look and there is almost 12 inches between each tree, so I am happy with that, the photo is a little bit deceptive of spacing due to the angle. I will lift my maples and elms to sort the nebari though.
Regards jasonb
Regards jasonb
-
- Aussie Bonsai Fan
- Posts: 793
- Joined: March 12th, 2011, 8:00 pm
- Favorite Species: maple
- Bonsai Age: 10
- Location: Perth
- Has thanked: 1 time
- Been thanked: 9 times
Re: Finally have my ground growing area!!!
Hi mate. Nice area for growing . 12 inches is very close. I would be going nearly a meter square for each tree depending on how big they are going to get eg. Chinese elms trident maple would need at least this. Smaller shrubs not so much . The low branches will help fatten the trunk adding taper so keep and encourage these .
Paul
Paul
-
- Aussie Bonsai Fan
- Posts: 1904
- Joined: January 12th, 2010, 12:02 pm
- Favorite Species: many
- Bonsai Age: 25
- Bonsai Club: yarra valley
- Location: vic
- Been thanked: 1 time
Re: Finally have my ground growing area!!!
Hi Jason growing trees is like building a house you start from the foundations and work up so nebari is first then you work on one section of the trunk at a time using low growing sacrifice branches to thicken each section. If you try to work on the whole trunk at once you will end up with poor taper. I grow my trees in pots for 2-3 years to get the roots in order and the lower trunk wired for movement, also try to have the sacrifice branches in place before they get planted out
Craigw
Craigw
-
- Aussie Bonsai Fan
- Posts: 212
- Joined: October 11th, 2012, 1:56 pm
- Favorite Species: Juniper/azalea
- Bonsai Age: 1
- Location: Blue mountains nsw
- Been thanked: 1 time
- Contact:
Finally have my ground growing area!!!
This is all a learning curve for me here guys, so again thank you, these posts alone are going to be very beneficial to my trees health. In regards to nebari, I am only interested with that on my deciduous trees and all but one, have no low branches. Is this going to a reverse taper possibility?
Jasonb
Jasonb
- Mojo Moyogi
- Aussie Bonsai Fan
- Posts: 1656
- Joined: May 5th, 2009, 11:26 am
- Favorite Species: Maple, Elm, Hornbeam, Pine, Larch and Cedar
- Bonsai Age: 29
- Bonsai Club: Yarra Valley Bonsai Society
- Location: Yarra Ranges, VIC
- Been thanked: 1 time
Re: Finally have my ground growing area!!!
You might be raw Jason, but I reckon just about all of us with more experience would have loved to have had a ground growing area and trees in it in year one. You are on the right trackJasonb wrote:This is all a learning curve for me here guys, so again thank you...

Cheers,
Mojo
...Might as well face it, I'm addicted to Shohin...
"Any creative work can be roughly broken down into three components- design, technique and materials. Good design can carry poor technique and materials but no amount of expertise and beautiful materials can save poor design". Andrew McPherson - Furniture designer and artist
"Any creative work can be roughly broken down into three components- design, technique and materials. Good design can carry poor technique and materials but no amount of expertise and beautiful materials can save poor design". Andrew McPherson - Furniture designer and artist