Well I decided that this needed some work now that I have some carving tools
I Repotted about 6 months ago and found the tall Trunk had died, and there are no roots on that side at all. As a result a major rethink was required
the original trunk I had cut off was now going to be the front and I would cut off the complete dead section and carve it out. This would be the new back side
The "Daughter will still be so, but the Father

would be now much smaller.
the tree was repotted into a smaller Poly box now it would fit

and Ready to grow on for another year. It was potted with the left deeper in the pot to lower that side to make a better twin trunk out of it as the left trunk was too tall and I wanted to keep the bend in it.
During the carving I broke off a small branch on the top right of the trunk that now needs to regrow as this will become the new leader. Being Privet, I should have on next week
Comments and suggestions welcome and I will update as time progresses
ken
You do not have the required permissions to view the files attached to this post.