SANY0057.JPG
After seeing a needle juniper Shibui had in the process at an Albury/Wodonga Bonsai Meeting a few months ago i made the decision then i would give it a shot . I just needed a decent trunk ,SANY0058.JPG
well this is good enough at around 150mm at the base and 400mm high it should be an impressive Shimpaku . I purchased several Shimpaku plantsSANY0059.JPG
off Neil at Shibui's Nursery on Monday Night and inarched them onto this trunk today .SANY0060.JPG
I was blessed Karen had the day off work as i needed a couple of pairs of hands to ensure the fit was snug and secure . I used 2 plants utilizing 6 branches on the Shimps to create a good start for the conversionSANY0066.JPG
.I repotted the donors into bigger pots for plenty of root run prior to set the grafts . I also used 2 pieces of timber to support the pots SANY0069.JPG
and wired them to the stubs to prevent any accidental hits dislodging them SANY0070.JPG
. Give this a few footy seasons and i should have a half decent Shimpaku Juniper trainer to work on . Not a bad effort for a man of leisure Cheers Alpineart